JVC RX-778VBK Instructions Manual page 29

OPERATIONS ]
To use this remote control system, you need to connect the TV to the
MONITOR OUT jack on the rear panel (see page 7), and set the
TV's input mode to the proper position to which the receiver is
connected. Make sure you have connected the CD player or
MD recorder equipped with the TEXT COMPU LINK
remote control system. If not, you cannot use the
following functions.
On-Screen Operation buttons (on the remote control)
•
Showing the Disc Information on the TV
Screen
Press TEXT DISPLAY while "CD" or "MD" is
selected as the source.
The Disc Information screen appears on the TV.
@m
R¢i
[]
TRACK 3 : S 0 m e t h i n q n
TRACK 4 : Wh a t ' s u _ ?
TRACK 5:How are you
Q
SERAOH ] _DI]:DI]: MODE_
T T [ iNPUT] SLSETJ:PLAY I-
BACKJ
:61
--::71
--_:
--'91
@ Source name: CD or MD
@ Select [] or ["1, then press SET to change the disc.
@ ]¥ack numbers and track titles.
• The current playing (selected) track is indicated in
yellow.
• When you move ¢3= to a track number, you can
change the track information by pressing <1 / t>. Each
time you press the button, track infolTaation alternates
between its track title and its performer. (You can also
start playing the track by pressing SET.)
@ Select this (move CF in front), then press SET to go to
the DISC SEARCH screen (see page 36).
@ Select this (move C_ in from), then press SET to go to
the TITLE INPUT screen (see page 37).
@ This appears only when a CD Text is selected.
@ Disc infomaation such as the disc title, performer, and
music genre.
When this is selected ( CY in front), you can change the
disc information by pressing <1 / _. Each time you press
the button, disc infomaation (see "Note on @') changes.
@ Select [] or [1, then press SET to change the track.
@ Usable buttons and their functions for the current
selection.
Indication here will be changed according to what is
currently selected ( CY in front) on the screen. See "Note
on @:'
Note on @:
The following information wi!! appear on the display:
• For CD Text:
- Disc title
- Performer
-- Genre
- Song writer
- Composer
- Arranger
- Message
• For MD: only Disc Title will appear
Only recorded information wi!! be shown. If there is no data, "NO
DATA" will appear.
Note on @:
For example, the SET button wi!! be used to start play (PLAY), to go to
the next screen (ENTER), and to determine the selection (ENTER).
To exit from the Disc information screen:
Press EXIT.
Notes:
• Theon-screendisplaywilldisappearinthefollowingcase:
- if no operation is done forabout !0 minutes.
- if you do any operation other than explained in this section.
• To control the MD recorder using the TEXT COMPU LINK remote
control system, you have to change the source name shown on the
display from "TAPE" to "MD." (See page 12.)
• Some specia! characters and marks cannot be displayed correctljz
35