Advertisement
(2
Do not use the following
on the ceramic
glass cooktop:
. Do not use abrasive cleaners and scouring
pads, such as metal and some
nylon pads. They may scratch the cooktop,
making it more difficult
to clean.
. Do not use harsh cleaners,
such as chlorine
bleach, ammoma
or oven
cleaners,
as they may etch or discolor
the cooktop.
. Do not use dirty sponges,
cloths or paper towels, as they can leave soil or
lint on the cooktop
which can burn and cause discoloration.
Care & Cleaning
of Stainless
Steel
(some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the
appearance of stainless parts. Please refer to the table provided at the beginning of the Care & Cleaning
section in this
Use & Care Manual.
To Remove
and Replace
Oven Door
\
Removing
and Replacing
the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor- See Fig. 1).
2.
Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
3.
Insert the 2 screws into the door hinge holes located on the side of the hinge arm,
one into each hinge (See B Fig. 2).
4.
Close oven door until the door stops, (Do not force the door to close any further).
The placement of these screws should keep door open in about a 45 degree
position.
5.
Grasp oven door firmly on both sides and slide door up and off hinges at the same
angle. (See Fig. 3)
6.
To clean oven door, followthe instructions in the General Care & Cleaning table.
or
a Nail
2.
Fig. 2
about 45
To Replace Oven Door:
1.
Be sure the hinge arms remain at the45degree angle position. Be sure the screws
are still locking the hinge arms from moving. If the screws fall out of the hinge
holes, the hinge(s) may snap back against the oven frame and could pinch fingers
or chip the porcelain finish on the oven front frame.
Hold door at the sides near the top while resting the lower front of door on your
knee. Insert the door channels at the bottom of door over the door hinges, (See
Fig. 3).
Allow the door to slide down into the door hinges evenly at the same 45 degree
angle. The hinge arms should be inserted into the bottom corners as far as they
can go.
4.
Open door completely (horizontal with floor) and remove both screws from holes
in door hinges.
5.
Reinstall the 2 screws into the door liner (See C Fig. 2).
6.
If the door is not in alignment with the oven frame, remove door and repeat the
above steps.
Fig. 3
13
Advertisement
