Jenn-Air JFC2089HEP Use & Care Manual page 5

I NSTALLATI 0 N
Leveling
To enhance the appearance and maintain performance,
the refrigerator should be level.
3. Using hex head driver, turn the front adjustment
screws (A) on each side to raise or lower the front
of the refrigerator.
Note
• Complete any required door reversal, panel
installation and/or a water supply connection,
before leveling.
Materials Needed:
• 3/8"hex head driver
• Carpenter's level
1. Remove toe grille.
• Grasp firmly and pull outward
to unclip.
2. Remove bottom hinge cover(s).
• Place the eraser end of a pencil or similar blunt
tool in the cover notch.
Notch
Location
• Use slight pressure to pry the
cover loose.
• Continue to maintain
downward pressure to the
notched side of the cover while
swinging it off.
I Note
• Some models only have adjustment screws "A:'
,
.
Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
Using the carpenter's level, make sure front of
refrigerator is Y4"(6 ram) or '/8bubble higher than
back of refrigerator and that the refrigerator is level
from side to side.
6. Turn stabilizing legs ((3) clockwise until firmly
against floor.
7. Turn adjustment screws (A) counterclockwise to
allow the full weight of the refrigerator to rest on
the stabilizing legs.
8. Replace bracket cover(s).
• Position cover into the outer edge of the hinge.
• Swing the cover toward the cabinet and snap it
into place.
9. Replace the toe grille.
Note
• For proper reinstallation, ensure the "top" marking
on the interior of the toe grille is oriented correctly.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.