Fuel Shut Off Valve; Cutting Height Adjuster; Bypass Linkages - Husqvarna MZ5425S Operator's Manual

CONTROLS
Fuel Shut Off Valve
The fuel shut off valve is centered behind the rear
of the seat. The valve is off when the handle tab is
turned perpendicular to the fuel line.
IMPORTANT INFORMATION
Always raise the deck to the highest position
for transport.
Cutting Height Adjuster
The desired cutting height is set with the height pin.
The cutting height pedal releases the deck lift to place
the deck and the selected height.
For transport, push the lift pedal fully forward until the
deck lift latches in the transport (highest) position.
Fuel shut off valve in the CLOSED position.
8065-010
IMPORTANT INFORMATION
To obtain an even cutting height, it is
important that the air pressure in all tires is 15
psi / 103 kPa / 1 bar.
Bypass Linkages
Transaxle bypass linkages must be engaged when
pushing or pulling the mower. The release levers are
located on each side of the rear of the unit below the
rear engine plate. See Moving Machine By Hand in
the Operation section.
22
1. Release pedal
2, Height pin
Cut height selection pedals
I....
Right side, hydro release lever
8058-223
L
8058-059