Husqvarna MZ5425S Operator's Manual page 28

OPERATION
8. Press in and turn the ignition key to the start
position.
IMPORTANT INFORMATION
Do not run the starter for more than 5 seconds
each time. If the engine does not start, wait
about 10 seconds before retrying.
Turn to the start position
8050-780
9. When the engine starts, immediately release the
ignition key back to the run position.
10. Slowly push in the choke control knob, if it was
used to start a cold engine.
_ WARNINGt
Engine exhaust and certain vehicle
components contain or emit chemicals
considered to cause cancer, birth defects
or other reproductive system damage.
The engine exhaust contains carbon
monoxide, an odorless, colorless,
poisonous gas. Do not use the machine
in enclosed spaces.
Return to run position
8050W81
11. Set the engine speed with the throttle. Allow the
engine to run at a moderate speed, approximately
mid throttle, for 3-5 minutes before loading it too
heavily. USE FULL THROTTLE WHEN MOWING
(no choke).
28
Set the throttle
8058-159