OPERATION
Moving
Machine
By Hand
When pushing or pulling the mower, be sure to
engage the EZT Hydrogear bypass linkages. The EZT
bypass linkages are located on the rear of the frame,
below the rear engine guard.
1.
Raise the deck into the highest cutting position.
2.
Pull the EZT bypass linkages out and into the
slots. Release linkages to hold in the bypass
position.
3.
Release park brake.
4.
To reengage the EZT's to drive, reverse the above
procedure.
_
WARNINGt
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
Set bypass linkages into slots on both sides
8050-018
WARNINGt
Make no adjustments without:
•
the engine stopped,
•
the ignition key removed,
•
the parking brake activated
32