Table of Contents
Advertisement
PREPARATmON
CAUTION:
BEFORE PROCEEDING
WITH PREPARATION
OF TRACTOR:
e
$
m
$
Depress
clutch/brake
pedal fully and set parking brake.
Place gearshift/motion
control lever in "NEUTRAL"
position°
Place attachment
clutch in "DISENGAGED"
position°
Turn ignition key "OFF" and remove key.
Make sure the blade and all moving parts have completely
stopped.
Disconnect
spark plug wire from spark plug and place wire where it cannot come in contact
with plug,,
NOTE
ON SOME
MODEL
TRACTORS,
MINOR MODIFICATIONS
MAY BE NECESSARY
TO MOUNT
YOUR NEW GRASS
CATCHER,.
NOT ALL MODEL
TRACTORS
WILL NEED THE FOLLOWING
MODIFICATIONS.
CHECK
EACH STEP
CAREFULLYTO
DETERMINE
IF MODIFICATION
IS REQUIRED.. ONCE YOUR MODELTRACTOR
CONFORMS
TO THIS
SECTION
PROCEED
TO ASSEMBLY..
To Prepare your Grass Catcher you may need:
(1) Drill Motor
( t ) 7/16" Drill Bit
DRILL
SUPPORT
TUBE
MOUNTING
HOLES
IN DRAWBAR
(See Template)
On some model tractors, two 7tt6" holes must be ddlled in left side of the drawbar for mounting the support tube..
NOTE: To ease in drilling 7116" holes,
it may be necessary
to drill smaller pilot holes at the locations
indicated
14
Advertisement
Table of Contents
