Assembly - Husqvarna C342B Owner's Manual

ASSEMBLY
2.
,,
CHUTE LATCH ASSEMBLY
(See Fig. 8)
Use Hardware - - GROUP "F & G"
Assemble hardware shown (latch pin) to upper chute°
Press weld nut into rubber latch and assemble rubber
latch to lower chute, as shown..
Tighten all hardware securely.
#10 X I-tl8" SCREW
WASHERS
3116 X 314 X 16 GA.
SPLIT
SPACER
UPPER CHUTE
NUT
#10 X 51B"
WELD
NUT
LOCK WASHER
FIG. 8
UPPER CHUTE (See Figs. 9A & 9B)
No hardware required
I. Lower mower deck to its lowest cutting position.
2.. Assemble upper chute by inserting curved end into hole
in back of cover.
NOTE: Handle carefully so as not to damage dump bag
indicator..
3., Push in and turn upper chute until it is in line with lower
chute..
4.. Align the bosses on lower chute with alignment slots on
upper chute and slide together..
5.. Secure with rubber latch by hooking hole in latch over
latch pin.
DUMP BAG
UPPER INDICATOR HANDLE
CHUTE
COVER
FIG, 9A
ALIGNMENT
SLOT
LATCH PiN
RUBBER
LATCH
FIG,, 9B
l LEVEL MOWER DECK
No hardware required
Be sure deck is properly leveled for best mower perfor-
mance.. See your tractors owner's man ual for instructions
11