Advertisement
If the PinP button on the remote control is pressed MULTI
PICTURE will display.
A/B button
powE_
_ICTURB AUDIOSU_OUN_
@O00
Oc_
0
Q
_
R_CAL
NUL
PIC
MEnU
nETUn_
=
VOL
E
@ ®
2 Pictures
(Split)
input terminaF
AV1
PAL-N
_AV4
NTSC-M, PAL-M
576i, 576p
480i, 480p
AV1
AV2
1080i/50
1080i/60
720p/60
RGB1
STB
RGB2
Component
PinP button
RECALL button
RETURN button
SELECT
button
Activating the P-in-P mode from the RGB input screen ]
Pressing the PinP button one time will display 2 pictures.
• This mode can be available
from RGBI(DVI-PC)
and RGB2(RGB)
input.
• The speaker
icon can be shifted
up and down by pressing
the A/B
button;
the audio of the video will be output
from the side on which
the speaker
icon is located.
• The sub-screen
position
can be
selected
up and down
by pressing
'_
& SELECT
buttons.
@/AVl
• The sub-screen
can be selected
with
the AV1, AV2, AV3, AV4 and TV
channel
number
buttons
from the
status that the speaker
icon appears
on the left side of AV_ as shown in
the diagram
to the right.
• Pressing
the PinP button
again or the RETURN button
will cancel
the 2 pictures
display.
• "Frequency
Mode" in the Setup
Menu should
be set to Movie when
sub-screen
is the component
signal
of 1080i/50
or 1080i/60.
AV1 : Displays
the
VEDEO input
signal
of the sub
screen
Activating the Split mode from the video input screen
J
Pressing the PinP button one
time will display 2 pictures.
@_ _
[_
• The speaker
icon can be shifted
left
and right by pressing
the
A/B
button;
the audio of the video will be
output
from the side on which the
speaker
icon is located.
• The same video
input mode cannot
be selected
for both screens
at the
same time.
• Pressing
the PinP button
again or the RETURN button
will cancel
the 2 pictures
display.
• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.
AV1 _AV4
NTSC-M
PAL-N
PAL-M
O
©
O
O
O
O
O
O
O
O
O
O
O
O
AVl,AV2
RGB1
RGB2
576i
480i
1080i/50 1080i/60 720p/60
STB
Component
576p
480p
O
0
0
O
0
0
0
0
0
0
O
O
O
O
O
O
O
(O : Available
NOTE
• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not
change to power save mode.
• Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.
The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control or
the monitor.
• The display will go out inapproximately6 seconds.
34
v,o
Off-timer
On-timer
_
g_._
Input mode
Signal mode
Advertisement
