Hitachi 27FX48B Operating Manual page 16

Programmin the Remote
VCR Functions
This remote is designed to operate different types of VCR's. You must first program the remote to match the remote system
of your VCR.
Procedure
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. While holding down the VCR button on the remote, enter the 2-digit preset code that matches your VCR. (See
page 17 ~ page 18.) The remote will tum off your VCR when the correct 2 digit preset code is entered. When this
occurs, the remote control is programmed for your VCR. If the VCR does not turn off after 25 seconds, try a
different code.
The remote will now control your VCR
,
Notes
• If your VCR cannot be operated after performing the above procedures, this means that your VCR's code has
not been coded into the remote.
• In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult
your VCR operating guide.
• The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
• If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
• The MENU button will act as the VCR MENU button for HITACHI VCR's.
• The INPUT button will act as your VCR +100 button, if required.
Cable/Satellite Box Functions
This remote is designed to operate different types of Cable Boxes and Digital Satellite Systems. You must first program the
remote to match the remote system in your Cable / Satellite Box.
Procedure
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. While holding down the CABLE button on the remote, enter the 2 digit preset code (page 18 ~ page 19) that
matches your cable/satellite box. The remote will turn off your cable/satellite box when the correct 2 digit code is
entered. When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box
does not turn off after 5 seconds, try another 2 digit preset code.
The remote will now control your cable/satellite box.
.
Notes
If your cable/satellite box cannot be operated after performing the above procedures, this means that your
cable/satellite box code has not been precoded into the remote.
In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures,
please consult your cable/satellite box operating guide.
The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries, repeat the entire programming procedure stated above.
If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP function.
CABLE/SATELLITE BOX VCR
F-N
-16-