Installing Your Wine Cooler; Unpacking Yourwine Cooler; Levelingyourwine Cooler; Properair Circulation - Haier HVF042ABL User Manual

Installing Y our W ineCooler
Unpacking Your Wine Cooler
1. Remove all packaging material. This includesthe foam base and all
adhesive tape holding the wine cooler accessoriesinside and outside.
Slide out and remove plastic or foam guard used to secure the
compressor from shipping damage due ta vibration and shack.
2. Inspectand remove any remains of packing, tape or printed
materials before powering on the wine cooler.
Leveling Your Wine Cooler
Your wine cooler has four leveling legs which are located in the
front and rear comers of your wine coder. After properly placing your
wine cooler in itsfinal position, you can level your wine cooler.
Leveling legs can be adjusted by turning them clockwise to raise your
wine cooler or by turning them counterclockwise to lower
your wine cooler. The wine cooler door will close easier when the
leveling legs are extended.
Proper Air Circulation
• Toassure your winecoolerworksat the maximumefficiency it
was designedfor, you shouldinstallit in a location where there
is properair circulation, plumbingand electrical c onnections.
• Thefollowing
are recommended clearances around the
winecooler:
Sides............... 2 "(50ram)
Top.................... 2" (50mm)
Back.................. 2" (50mm)
• Do not over fill your wine cooler for proper internal air circulation.