Haier Room Air Conditioners User Manual page 25

Wall Hns_aHations: sJideooutchassis only
Note: Remove the ] or 2 shipping screws on the rear of the air conditioner
that hold the chassis to the outer sheJlcasing. Once removed,
these do not have to be reoinstalled. To ensure that your air
cendifioner is properJy instalbd in the walJ, it is recommended
that it be installed by a certified technician who is famiJiar with
through the wall instaHafions_
1) Using wood, 1" or more in thicknessr build a wooden frame to fit the
casing!cabinet dimensions of the unit which you have purchased.
2) Measure the outside width and the height of the frame to determine the
cutout dimensions necessary for the opening in the wall The depth of the
frame will depend on the depth of the wall. The finished frame must be set
in the inside wall. The frame has to be squared and leveled Remember the
frame has to be nailed securely to the wall studs (See Fig # ] 9)
wall
Fig. # 19
3) Now to instaH, insert the casing into the walJ opening. (Removethe
chassis out first following steps 1 - 6 in Slide-out chassis sectionI.
Make sure that the cabinet is at bast ]/2" inch inside the room. Also the
side buvers shouJd not be bbcked This is to have proper air circuJation in
and around the compressor. (See Fig. # 20)
24