Table of Contents
Advertisement
Available languages
Available languages
Unpacking
Your Freezer
1. Remove all packaging
material,
This includes the foam
base and all
adhesive
tape holding
the freezer accessories
inside and
outside.
2. Inspect and remove any remains
of packing,
tape or printed
materials
before powering
on the freezer.
Adjusting
Your
Freezer
• Your freezer
is designed
for freestanding
installation
only.
It should
not be recessed or built-in.
• Place the freezer
on a floor strong enough
to support
it fully loaded,
• When moving
the freezer,
never tilt it more than a 45-degree
angle.
This could damage
the compressor
and the sealed system.
• If the freezer
is tilted let it stand in an upright
position
for at least 24
hours prior to plugging.
This is to allow the refrigerant
to settle.
Proper
Air Circulation
• To assure your freezer works at the maximum
efficiency
it
was designed
for, you should install it in a location
where there
is proper
air circulation,
plumbing
and electrical
connections.
• The following
are recommended
clearances
around
the refrigerator:
Sides ...............
4" (102mm)
Top ....................
4" (102ram)
Back ..................
4" (102ram)
Advertisement
Table of Contents
