SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Contents Chapter 1 General Information ......................3 1-1. General Guidelines ........................3 1-2. Insulation Test ..........................3 1-3. How to read this Service Manual ....................4 Chapter 2 Product Feature ........................5 2-1.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Chapter 1 General Information 1-1. General Guidelines When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed.
Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA 13. Don’t touch the refrigeration surface of the freezing compartment when the refrigerator is in operation, especially when our hand is wet, else we may be glued to the surface. 14. Pull out the plug of power supply during clearance or power outage. Wait at least five minutes to resume the power supply in order to prevent damage to the compressor caused by continuous restart.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Chapter 3 Installation, adjustments and maintenance 3-1. Installation The freezer should be conveniently located for day-to-day use in a dry well-ventilated room. Do not install the freezer where the temperature will go below 0°F or above 110°F, because it will not maintain proper temperatures.
Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA freezer. Water may drip from the back flange of the lid cover during defrosting. This is normal. Ice builds up in the lid insulation when the lid is open for adding or removing food, and melts during the defrosting operation.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Chapter 4 Disassembly 4-1. Door assembly (Door, hinge, hinge cover) Unscrew the hinge cover screw with screwdriver, take away the top and bottom cover by pull it, and then unscrew the screws on the hinge, so the whole hinge could be moved.
Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA 4-3. Control panel assembly (Panel, cover board, knob, indicator light) Unscrew the compartment grill (refer 4-2), push the panel claw gently with our finger or tools, at the same time pull panel outside then take away it.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA 4-4. Thermostat assembly First take off the knob (refer 4-3), Use turnbuckle spanner or acutilingual plier unscrew the turnbuckle, and then thermostat can be moved from back of panel. Note: When assembly thermostat we should placed thermostat in originally direction.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Chapter 5 Control and display system 5-1. Control panel Freezing temperature selection is made by setting the control from 1to 7(coldest). If we want colder or warmer temperatures, adjust the control one step at a time.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Chapter 6 System flow principle 6-1. Refrigeration flow chart The refrigeration system of direct cooling single-system cooler belongs to the category of a single-temperature and single-control refrigerating system with one evaporators and is controlled by a...
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA Chapter 8 Trouble shooting 8-1. Normal phenomena Problem Possible Causes What To Do Temperature control in OFF or Move the control to a temperature setting. Min or 0 position. Freezer does not operate Freezer is unplugged.
Page 17
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA fuse blown/circuit Replace fuse or reset the breaker breaker is tripped. Check to see if package is holding door/lid Door/lid left open. open. Too frequent or too long door/lid openings. Temperature control set too See About the operation of the freezer cold.
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA 8-2. Abnormal phenomena 8-2-1. No cooling No cooling Whether the freezer can start Test according to the process of the freezer can not start Exchange the thermostat Whether the temperature knob on “off” position...
Page 19
SERVICE MANUAL Issue 2013-11-21 Rev. Mod el: HCM071PA Ref1311S001V0 8-2-2.Compressor no start Compressor no start Connect the power Check if the home power is connecter Adjust thermostat setting position Ambient temperature >25℃ 1~3 Grade Check if thermostat is set at Ambient temperature <25℃...
Page 20
SERVICE MANUAL Issue 2013-11-21 Rev. Ref1311S001V0 Mod el: HCM071PA...
Page 21
Sincere forever Haier Group Haier Industrial Park, No.1, Haier Road 266101, Qingdao, China http://www.haier.com...