How To Install The Unit; How To Use The Reversible Inlet Grille - Goldstar R1402 Owner's Manual

How to Install the Unit
_ ¸¸.¸4
._:._ ......
1/4 Bubble
INSIDE OUTSIDE FENCE
AWNING
FOAM ...........
COOLE_I HEAT
RADIATION
About 1/2"
Over 20"
1. To avoid vibration and noise, make sure the unit: is installed securely and firmly.
2. Install the unit where the sunlight does not shine directly on the unit.
if the unit receives direct sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, like a fence, within 20" which might restrict heat radiation from the
_ndenser.
4. To prevent reducing performance, install the unit so that louvers of the cabinet are not blocked.
5. Install the unit a little obliquely outward not to, avoid leaking the condensed water into the room
(about 1/2" or 1/4 bubble with level).
6. install the unit with its bottom portion 30~60" above the floor level.
7. Stuff the foam between the top of the unit and the wa!l to prevent air and insects from getting into
the room.
8. The power cord must be connected to an independent circuit. The green wire must be grounded.
9. Connect the drain tube to the base pan hole in the rear side if you need to drain (_nsult a dealer.)
Plastic hose or equivalent may be connected to the drain tube.
How to Use the Reversible Inlet Grille
The grille is designed to clean the filter _th upward and downward.
®
(a}
A. Before attaching
w
(b)
the front grille to the cabinet, if you want to,puff out the
1. Open the inlet grille slightly (a).
2. Turn inside out the front grille (a).
3. Disassemble the inlet grille from the front grille with separating the hinged part by inserting a
straight type _rew-driver tip (b).
4. Then, rotate the inlet grille 180 degrees and insert the hooks into bottom holes of the front grille.
5. Insert the filter and attach the front grille to the cabinet.(Refer to page 7)
B. If you want to pull out the filter downward;
The grille is already designed that way,