Air Direction - Goldstar R1402 Owner's Manual

Additional controls and important information.
The ventilation lever must be in the CLOSE _sition in order to maintain the best cooling _nditions.
When fresh air is necessary in the room, set the ventilation lever to the OPEN position.
The damper is opened and room air is drawn out.
NOTE:
Before using the ventilation feature,
poslti,on the lever, as shown. First, pull down
part (&}to horizontal line with part _).
Air Direction
The dir_tion of air can be controlled wherever you want to
cool by adjusting the horizontal louver and the verticai
louver.,
• HORIZONTAL AIR-DIRECTION CONTROL
To control horizontal direction of air flow, set to the ON
position the air-swing switch and the air flow will be swept
horizontally by the automatic air-swing system.
if you want to stop the air flow from moving, switch off the
air swing switch at the desired position of the vane.
. VERTICAL AIR-DIRECTION CONTROL
The vertical air direction is adjusted by moving the
horizontal louver.
How to Attach Drain Pan
The air _nditioner employs a proper drain method whereby the condensed water (moisture removed from
the air) is drained to the outside.
In very humid weather, (and for reverse cycle mo_ls in the rever_ mode) excessive condensate water
removed from the air may cause some w_er to collect. To remove this excess water you can instaii the
drain p_ as detail_ below.
1. Take the drain pan which is located in the air di_haJge.
2. Remove the hole rubber from the base-pan (for some models).
3. Install the drain pan to the fight _mer of the cabinet with 4 (or 2)
screws.
4. Connect the drain hose of 3/5"insi_ diameter to the outlet located
at the _ttom of the drain p_.You _n purcha_ the drain hose or
tubing locallyto saSsfy your particular needs. (Drain hose is not
supplied).
CABINET
PAN
DRAIN HOSE