Advertisement
Tools
Required:
, Phillips Screwdriver
11mm ]3mm. ISmm. 17ram.19mm Socketand CombinationWrenches
e 5ramA!len Wrench
o CrankPuller
Procedure:
!i:ii{:!ii_
L Remove crank disk and side covers.,'Reference CrankDisk!SideCover/Crank ArrnReplacement
-L2E & 2.2E or 3.2E & 4.2Eon PPd
2. Checkthe tensionof the drive belt.
Thecorrectbelt tensiontoleranceis I20=J40 /bs. Ira belt tensiongauge Is nor
available, the drive belt should have about0.25" deflectionwhenpressing down
firmly on the drive belt.
3. Loosenboth nuts (A),which hold the flywheelto frame.
37
02
12
R09
R20
R08
Rt2
4. Tightenor loosenthe nuts (B)holding the tensioningbolts flTtoposition on both sides of the flywheel
to adjust the tensionof the drive belt.
Makesure that both bolts are tightened equally sothat fi}w@ee! sits straight in frame and
both the fi_/wheel and Crankpulleyare properlyalL,ned.
5. Oncethe belt tensionis set properly,tighten the nuts (.4)on both sides of the flywheel
Advertisement
