Table of Contents
Advertisement
Replace agitator cover (N) and 2
screws.
Replace hood, 2 screws and hose.
Raise nozzle up and replace the 2
screws on the bottom.
The agitater
brush
roll
When
te replace
When agitator brushes are worn, the
agitator should be replaced.
];o check condition of brushes, discon-
nect cleaner from electrical
outlet.
Move edge of a card across bottom
plate while turning agitator. To maintain
cleaning effectiveness,
replace agitator
if brushes do not touch card.
What
to buy
When purchasing
a new agitator, ask for
HOOVER part no. 48414110.
How
to replace
Disconnect
cleaner
from
electrical
outlet.
Remove hood and agitator cover as
described
in the "Belt replacement"
section.
Discard old agitator.
Continue following the directions in the
"Belt replacement"
section to replace
belt, new agitator, agitator cover and
hood.
The motor is equipped with bearings
that contain sufficient lubrication for the
life of the motor. The addition of lubricant
could cause damage. Therefore, do
not add lubricant to motor
bearings.
The agitator brush roll is equipped
with
two ball bearings that should be lubd=
cated periodically
by a Hoover Factory
Service Center or an Authorized
Hoover
Warranty Service Dealer (Depot).
Thermal
protector
An internal thermal protector has been
designed into your cleaner to protect it
from overheating=
When the thermal
protector
activates,
the cleaner
will stop running.
If this
happens, proceed as follows:
I. Turn the cleaner OFF and distort=
nect it from the electrical
outlet.
2= Check filters for dirt accumulation.
3= Refer to "Clearing blockages"
section.
4. When cleaner
is unplugged
and
the motor sools for 30 minutes,
the
thermal protector automatically
resets
and cleaning may continue.
If the thermal protector continues to
activate after following the above steps,
your cleaner may need servicing
(see"Service"
section).
10
Advertisement
Table of Contents
