To Start Unit; Function Control (Mode); Moneysaver Switch; To Remove The Filter - Friedrich QStar SQ05 Operating Manual

Howto operateyourFriedrichroomair conditioner
Ill I
TM
I I1 QSTARO
Super High Efficiency Open
0 j
FonOA'Low
oo, !lF oo,
rl_tT/q.N •
Closed
9 Lrz'_'_
Wait three minutes before restarting
Figure 2
To start unit
If your air conditioner is installed and plugged into a proper
receptacle, it is ready to operate.
FunctionControl(Mode)
The dial control allows you to select cooling at three
different speeds, as well as FAN ONLY.
Turn to OFF to turn everything off.
Turn to HI COOL for quick cooling.
Turn to MED COOL to maintain a desired temperature.
Turn to LOW COOL for night time use, or when demand
is low.
The FAN ONLY setting will circulate air in the room
without the compressor coming on. The FAN ONLY setting
can also be used with the vent open to remove stale air or
smoke from the room.
Temperaturecontrol
This dial is the thermostat. Turn it clockwise for cooler and
counterclockwise for warmer.
MoneySaver ® switch
This rocker switch can be depressed to either YES or NO.
In the YES position you will get the most economical op-
eration. Both the fan and compressor will cycle on and off
together, maintaining the selected temperature at a more
constant level and reducing the humidity more efficiently.
This control will only operate when the unit is in a cool-
ing mode. In the NO position, the fan will run constantly.
Exhaustcontrol
By placing the lever in the VENT OPEN (Figure 2) position,
stale air and smoke can be exhausted from the room. The
unit should be placed in the FAN ONLY position to expedite
the flow of air to the outside. For normal cooling the vent
should be in the closed position for maximum performance
(Figure 2).
To removethe filter
The diagram below is a guide to filter replacement. Simply
turn the unit off and pull the filter frame up and toward
you. Clean the filter with warm water and a mild detergent,
rinse, dry, and replace by sliding the filter back into position
behind the front panel.
Figure 3