Recovery Tank; How To Empty; Carpet/Upholstery Detergent; Bare Floor Cleaner - Hoover SteamVac F7210-900 Owner's Manual

Hide thumbs Also See for SteamVac F7210-900:
Table of Contents

Advertisement

P-,_P4
P_EI
IE
Carry tank to a sink.
Turn tank cap counterclockwise
and
remove cap.
Fill tank (E) (1 gallon) with hot tap water.
CAUTION:
Do not fill with water above
140°F (60°C).
Replace tank cap and tighten.
To fill detergent container (F), turn cap
counterclockwise
and remove cap.
NOTE:
Use only
HOOVER
detergents.
They are specially
formulated
for use
with your 'SteamVac'
deep
cleaner.
CAUTION:
Detergents
contain
Anionic
and Nonionic
Surfactants.
Avoid
contact
with eyes
and skin.
In
case
of contact
with eyes,
flush with
cold water
for 15 minutes.
In case of
contact
with skin, wash
with water,
if
irritation
persists,
call a physician.
For Medical
Information
(U.S.)
call
1-800-752-7869.
Fill container (16 oz.) with HOOVER
Carpet/Upholstery
Detergent or
HOOVER Bare Floor Cleaner.
Do not use Bare Floor Cleaner on carpet or
upholstery. Do not use any type of wax
with your 'SteamVac' deep cleaner.
To assure proper results, use only
HOOVER detergent.
Replace container cap and tighten.
Position bottom of tank onto cleaner and
pivot tank to snap it into place.
Recovery
tank
(lower
tank)
The recovery tank holds tile dirty solu-
tion that is picked up from the surface
being cleaned.
When the recovery tank is full, the auto-
matic shut-off will engage, suction will
stop (see page 7), and the tank must be
emptied.
How
to empty
Turn deep cleaner off and unplug
from electrical outlet.
To prevent possible leaking, remove
clean water tank (Fig. 2-10) by pressing
down on tank handle and pulling for-
ward; set tank aside (do not set tank
on furniture).
Step on handle release pedal (Fig. 2-3)
and lower handle until it rests on the
floor.
Turn recovery tank latches (G) outward
(one on each side of tank).
Raise handle (H) straight up and lift tank
off cleaner.
Carry tank to sink or drain.
Lower handle toward back of tank to
unlock lid. Lift lid off tank.
Empty tank and reposition lid.
For full suction,
it is important
that
the recovery
tank lid is properly
secured
before cleaning.
Raise tank handle to carrying position
and place it onto deep cleaner. Lower
handle to front of tank.
Turn latches (one on each side of tank)
inward to lock tank in place.
Raise handle of deep cleaner to upright
position and reposition upper clean
water tank.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Steamvac v2

Table of Contents