Table of Contents
Advertisement
n for
scrubbing
or Off if
ing Is not desired.
Dry hands and plug deep cleaner into
a properly grounded outlet.
Step on handle release pedal and lower
handle to operating position;turn deep.
cleaner ON.
To release solution,press trigger.Slowly
move deep cleaner forward and back-
ward over area to be cleaned.
To pick up dirty solution,release trigger
and slowly movedeep cleaner over
area where solutionhas just been dis-
pensed. Use both forward and reverse
strokes.
Empty recoverytank when the motor
sound becomes higher pitched and
there is a loss in suction(see
"Automaticshut-off', page 7)
When finishedcleaning,follow 'After
cleaning"instructionson pages 9-10.
Remove attachmentfrom nozzle and
rinse in clear water. Do not remove
plastio screen or foam from attach-
men*,.
The poweredhandtool (Ultramodels.)
has rotating brushes for extrascrubbing
actionon small carpet areas, carpeted
stairs and upholstery.
The stair/upholstery n ozzlehas a built-in
brush to help provide the scrubbing
actionsomespots may need for
removal.
The utilitynozzle (some models)can be
usedfor carpet and upholsteryin vehi-
cles.
How to attach
tool
Disconnect deep cleaner from electri-
cal outlet.
Placehandlein uprightpositionand
removehose from rack.
J_Connect
poweredhand tool (A)'or
stair/upholstery nozzleor utility
nozzle(8) to end of hose by sliding it
ontoconnectoruntilthe tab (C) locks it
securely.
Using your thumb, push forward and
up on the latch(D) to removetool as
shown.
Followthe instructions on pages1 1-12
for the appropriatecleaningtask.
C
Before
using
tool
It may be necessaryto remove air from
the system(=pdme the pump")so the
clean solutionwill flow to the toot.Follow
these steps:
1. Attach tool to hose and turn the deep
cleaner ON.
?,,Putthe tool on a hardsurfaceor
againstyour handto blockoff the suc-
tion,
3. Wait a few seconds(can take up to
15 seconds). Then squeezethe trigger
and begin cleaning.
Follow the instructionson pages 11-12
for the appropriatecleaningtask.
4. Disconnectdeep cleaner from electri-
cal outlet.
5. Drain solutiontube (locatedinside
hose) by pointingend of hose in sink
and pressingtrigger.
6. Proceedwith steps c. d, and e, for
'After cleaning"on page 9.
After
using
tool
1. Followstepsa and b for *Afterclean-
ing" on page 9.
2. Rinsetooland hose by filling sink
with a smallamountof water,Turn
deep cleaner ON and pickup the
waterwith the tool,
[_.
Drain hose by turning deep
cleanerON and holdingend of
hose up for severalseconds,Do not
press trigger,
Read "Before you begin cleaning"
instructionson page 9.
Placehandle,in upright position.
Agitator brushes will not rotate while
handle is in upright position.
Fill cleansolutiontank with HOOVER
Carpet/Upholstery Detergentaccording
to instructions on pages 7 and 8, Attach
toot to end of hose,
Hose length may require that machine
be placed at the top of the stairsto clean
upper half of stairway and at bottom of
stairs to clean lower hall
To prevent machine from failing, use
extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward people or
pets. Dry hands and plug deep cleaner
into a properly grounded outlet.
Turn deep cleaner ON.
['_
Pre-spray the carpeted stair by
holding the tool (A) or (B) about
one inch above the carpet and push it
forward while pressing the trigger
(equals one wet stroke).
Position tool against the riserand slightly
pressit into carpet pile. Press the trigger
and pullthe tool slowly over the carpet
(second wet stroke). Releasetrigger at end
of stroke.
Continued
-@'11
Hide quick links:
Advertisement
Table of Contents
