Hitachi VT-UX6430A Owner's Manual page 35

• Locating the beginning of a blank section (BLANK SEARCH)
This function searches for a non-recorded section of remaining tape, or
unused tape, and stops the tape when it locates such a section.
Notes:
• BLANKSEARCHcannotbeoperatedwithacassettewithoutasafetytab.
• BLANK SEARCH may not operate when a blank section lasts no more than
five minutes.
• BLANK SEARCH will not be engaged in the following sections since they
are not recognized as blanks:
--Sections with noise
--Sections where only sound has been recorded
--Sections where previous recordings have been erased
_OCDO
VIEW/SKIP/
- BLANK
O Press the _ (VIEW/SKIP/
BLANK) butt<)n in the STOP
mode,
The BLANK SEARCH screen will
appear and the tape will fast
forward automatically.
• The blank which is the nearest
the current tape position is
searched for.
• The blank square in the tape
bar shows the current tape
position.
• The tape remaining time
appears on the screen and
VCR display during BLANK
SEARCH.
• When a blank is detected, the
tape will automatically rewind.
to the beginning of the blank.
"- Notes:
• When a cassette without a ,
safety tab is inserted, "TAb"
will flash in the VCR display
for several seconds and the
cassette will be ejected
automatically.
• Tape bar will not appear
correctly if tapes which have
scratches or are slack are
being used.
I
Tape bar Tape Remaining
[ I.I-F a
11
eeeegooee_ooe_omoelleeeooe,oeeeeooeeooo,lmeooemoo
!
i
When the beginning of blank is
located, the STOP screen will
appear for five seconds and the
tape will stop.
• The tape remaining time
appears in the VCR display.
AUTO REM 1:35 EP
o
U.I
O,,._
I " I/
I'_1_/
;;;e ;; ======================== ""
recording or editing.
35