Hitachi VT-UX6430A Owner's Manual page 17

• Setting the channel and clock automatically
Switch on at the mains supply socket after completely connecting all
leads, Please refer to page 10 to 16 on "HOOKUP" sections.
The VCR will be in the standby mode at this stage•
Press the POWER button on the
VCR to start the auto install•
_,_I o _ ',I !_-_Y:.{
=o , ___,
POWER
This screen appears to show that
the channel is being set.
After the channels are stored in
memory, the clock set will run
immediately.
The screen appears to show that
the clock is being set.
The dash " - " puts out lights one
by one as shown on the VCR's
display.
• The VCR will automatically store
channels received in your area.
• It takes about 2 - 3 minutes.
pLEASE WArT
CHANNEL 15SETTING
CANCEU_[_
J,
PLEASE WAIT
CLOCK ISSETrlNG
CANCEL_
I[ ::';;]
1
.vc.oo u
• o /L/
[ VCR_
• = /W
[ VCR_
• ° /5
When the auto install is complete,
the channel with the lowest I
I
number and the correct time
appears in the VCR's display.
I
F/- --'iF/VCR_
Notes
• If you press the POWER button inadvertently before connecting all leads,
follow the steps on page 22 for further tuning function.
• If you press the POWER button during auto install mode, the VCR
automatically switches to the STOP mode.
o,.
p.
uJ
u}
uJ
l-
iv.
17