Haier CHER203AAWW User Manual page 11

CORD CONNECTED APPLIANCES
We recommend that you have the electrical hookup of your range done by a qualified
electrician. Have the electrician show you where your range disconnect is located. If you
fail to wire your range in accordance with governing codes, you may create a hazardous
condition.
Relizr to the range's rating plate lor electrical requirements. The raling plate is located in
the burner box area on freestanding ranges and cook tops. Lift up the fi'ont edge of the
main top to find the rating plate. On huilt-in wall ovens, the plate can be lound in the
storage compartment. Open the storage door panel to find the rating plate.
Rating Plate
You nmst use a three-wire, single-phase AC 208/240 Volt, 60 Hertz electrical system to
operate your range. Use #8 wire and 40 Amp litse or circuit breaker lor 240 Volt and 208
Volt systems.
For ranges equipped with a terminal block, use only a 3-conductor or 4-conductor UL
listed 40 Amp 125/250 mininmnl volt electric range power cord. The cord nmst have open
end spade lugs with upturned ends or closed loop terminals. An appropriate strain relief
bracket nmst be provided on the power cord. Power cord strain relief must be used.
It is strongly suggested that your electric range be connected by means of a cord utilizing
copper conductors. Copper has always proven itself to he the most dependable
conductor. Howevec many homes may be wired to connect to a range by means of
almninum wiring. This is not an ideal situation, and we urge you to have a qualified
electrician change to a copper cord connection. If this is not possible, hare wire
connections can be made with the terminal adaptor kit packed in with the range.
ADAPTOR CONNECTION Use for bare wire connection through electrical condu_t
20 ici.,L6 7brq_"
7brq_w @
SET SCREW
INSERT WIRE INTO BLOCKS
TIGHTEN THE SET SCREWS. SECTION VIEW
11