Advertisement
Available languages
Available languages
Lubrication
DEWALT tools are properly lubricated at the factory and are ready
for use.
Repairs
To assure product SAFETY and RELIABILITY,
repairs, mainte-
nance and adjustment should be performed by authorized service
centers or other qualified service personnel. Always use identical
replacement parts.
Motor
Brushes
When brushes become worn, the tool will automatically stop, pre-
venting damage to the motor. Brush replacement should be per-
formed by DEWALT authorized service centers or other qualified
service personnel. Qualified service personnel should follow the
procedures below when replacing motor brushes.
Turn off and unplug
tool before making any adjustments
or
removing
or installing
accessories.
Before reconnecting
the
tool, depress and release the trigger switch
to ensure that the
tool is off.
1. Remove the brush doors located on the sides of motor housing.
2. To remove the brush,
hold the female terminal,
which is
attached to the brush lead wire, and disconnect the female ter-
minal from the male terminal.
3. Pull the brush straight up out of the brush holder.
4. Replace brushes, in pairs, with original DEWALT brushes avail-
able from DEWALT authorized service centers.
5. Ensure that the brushes slide freely in brush box.
6. Reconnect the brush lead wire to brush box terminal.
7. Re-install the brush doors before using the tool. Torque screws
to 10 in./Ibs., maximum. Overtightening
may cause screws to
strip.
Purchasing
Accessories
Recommended
accessories for use with your tool are available at
extra cost from you local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, contact:
DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286.
_CAUTION:
Accessories
must be rated for at least the speed
recommended on the tool warning label Wheels and other acces-
sories running over rated speed can fly apart and cause injuoz.
Accessory ratings must always be above tool speed as shown on
tool nameplate.
A CAUTION:
The use of any other accessory not recommended
for use with this tool could be hazardous.
Three
Year
Limited
Warranty
DEWALT will repair, without charge, any defects due to faulty mate-
rials or workmanship
for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-DEWALT (1-800-
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others.
This warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, DEWALT tools are covered by our:
1 YEAR FREE SERVICE
DEWALT will maintain the tool and replace worn parts caused by
normal use, for free, any time during the first year after purchase.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of your
16
Advertisement
