Zenith VR4285HF Operating Manual & Warranty page 31

VCR PLUS RECORDING SETUP/Step C
Preliminary Setup, Cable Service with a Cable Box
Cable Box
Tunes to
Channel 19
Cable Box
_j[ i_/.._, _.-'/ IR (Infra Red)
['f.j_ v.._._.lr"j/ Signal Path
_:_'_J_"V" _ v_'//1" from VCR
I. _"
]
// to Cable Box
la¢
Wall, Window
or any
Reflective
Surface to
Bounce IR
Signals
to
Cable Box
/j"
J
/
L..f j j//--
• - - Do Auto Channel. Search procedure.
• - - Clock must be set to correct time.
-- Source Select must be set to Tuner.
-- Tuning Band must be set to CATV.
-- VCR, cable box and TV must be turned On.
-- TV/VCR SOURCE set to VCR (VCR appears
in Message Center.)
-- TV on and tuned to Channel 3, or TV
Audio/Video In as the source of the TV picture,
as appropriate.
i VCR tuned to cable box output channel number:
2, 3, 4, 5 or 6.
-- Cable box must be connected to VCR ANT IN
(IN FROM ANT).
-- IR (Infra Red) Signal path from the VCR to the
cable box must be unobstructed.
Write In:
Cable Box Output Channel Number
1. For the Cable Box Test
Get the following information and enter in appropri-
ate spaces below.
Cable Box Output Channel Number.
May be printed in cable box owner's manual or on
cable box. It"not. call cable company for number;
2, 3, 4, 5 or 6.
"MFR" Number.
A series of numbers for your particular cable box.
If the first number does not work, try all the others
in sequence. See page 1:2-:3.
2. Complete VCR Plus Channel Mapping Work-
sheet.
See page 12.-4
Press CH MAP to begin VCR Plus Setup,
follow on-screen instructions.
If cable box test is succe.ssful, the cable box will
tune to Channel 19 as shown above.
"MFR" Number(s)
_o-0 12 -- 2