Table of Contents
Advertisement
WATCHING TV (TV Antenna
In Connections)
• POWER
• STOP
,& EJECT
L-AUDIO'-
VIDEO
EtEEIE' /E'.',_q/_7,, . ...
_.
\
Note: This setup
(Antenna In TV Connections)
requires
that the TV be tunecl to the same channel
that the VCR Ch3-4 Switch is set at, either Channel 3 or 4.
There are three tuning options available
to you for selecting channels
to watch on your TV. You can use the TV tuner, the VCR tuner, or
the cable box itself (if you have a cable box.) (See Service Informa-
tion chapter for System Operation
Chart.)
TV Tuning
1. Turn
TV and VCR on.
2, Switch
Remote
to VCR mode.
3. Switch TV/VCR SOURCE
to TV, to turn off VCR indicator
in VCR Message Center.
4. Switch Remote to TV mode. Select channels with Remote or
TV controls.
Note: Remote will operate
most Zenith TVs.
VCR Tuning
1. Turn TV and VCR on, tune TV to Channel 3.
2. Switch Remote to VCR mode.
3. Switch TV/VCR
SOURCE to VCR, VCR indicator
appears
in VCR Message Center.
4. Select
desired
channel
with
Remote
or VCR
Channel
Up/Down.
Cable
Box Tuning
1. Turn
TV, VCR and cable
box on, tune TV to Channel
3.
2. Switch
Remote
to VCR
mode.
Tune VCR to your
cable
box
output
channel
number;
2, 3, 4, 5 or 6.
3. Switch
TV/VCR
SOURCE
to VCR,
VCR indicator
appears
in VCR Message
Center.
4. Tune cable
box to desired
channel
number.
UGHT
29a-o2-o
6 -- 1
Advertisement
Table of Contents
