Table of Contents
Advertisement
INDICATOR
LIGHT
_HT
•AC RECEPTACLE
Output and Overload
indicators
The output indicator
light (green) will remain ON during operating
conditions.
If the generator
is overloaded
(more than 1.OK VA), or if there is short in the
connected
appliance,
the output indicator
light (green)
will go OFF, the overload
indicator
light (red) will go ON and current to the connected
appliance
will be
shut off.
Stop the engine if the overload
light (red) comes
ON and investigate
the
overload
source, start it after the overload
light is OFF.
• Before connecting
on appliance to the generator,
check that it is in good order,
and its electrical
rating does not exceed the power of the generator.
Then connect
the power cord of the appliance,
and start the engine.
(_) DC application
The DC receptacle
may be used for charging
12 volt automotive-type
batteries
only.
• To prevent
from creating
a spark near the battery, connect
charg-
ing cable first to the generator,
then to the battery, Disconnect
cable first at
the battery.
• Connect
the positive
battery terminal
to the positive charging
cord.
Do not reverse the charging
cables, or serious
damage
to the generator
and battery may occur.
NOTE:
• An overloaded DC circuit will trip the DC circuit protector (push button comes
out). The DC circuit protector will trip when it's overloaded. If this happens,
wait a few minutes before pushing in the circuit protector
before resuming operation.
•DC CIRCUIT
PROTECTOR
i,i
No
ON
OFF
-PLUG
!!
13
14
Advertisement
Table of Contents
