Troubleshootmng - Generac Portable Products 2300PSI 1674-0 Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

bye&
S_on
_
_7_
POWER p_C_UC rs
TROUBLESHOOTmNG
Problem
Pump
has following
problems:
failure
to
produce
pressure,
erratic
pressure,
chattering,
loss
of pressure,
low water
volume.
Detergent
fails to mix
with spray.
Cause
I.
Nozzle in low pressure mode.
2.
Water
inlet is blocked.
3.
Inadequate water supply.
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
6.
Water
supply is over 100°F.
7.
High pressure hose is blocked or
leal<s.
8.
Gun leal<s.
9.
Nozzle is obstructed.
10. Pump is fault 7.
I.
Detergent
siphoning tube is not
submerged.
2.
Chemical filter is clogged.
3.
Dirty in-line filter.
4.
Nozzle is in high pressure mode.
Engine runs good at no-
Engine speed is too slow.
load but "bogs"
when
load is added.
Engine
will
not start;
or
starts
and
runs
rough.
Engine shuts down during
operation.
Engine lacks power.
Engine "hunts"
or falters.
I.
Dirty air cleaner.
2.
Out of gasoline.
3.
Stale gasoline.
4.
Spark plug wire not connected to
spark plug.
5.
Bad spark plug.
6.
Water
in gasoline.
7.
Overchoking.
8.
Excessively rich fuel mixture.
9.
Intake valve stuck open or closed.
10. Engine has lost compression.
Correction
I.
Pull nozzle backward for high pressure
mode.
2.
Clear inlet.
3.
Provide adequate water flow.
4.
Straighten inlet hose, patch leal<.
5.
Check and clean inlet hose strainer.
6.
Provide cooler water supply.
7.
Clear blocks in outlet
hose.
8.
Replace gun.
9.
Clean nozzle.
10. Contact
Generac service facility.
I.
Insert detergent siphoning tube into
detergent.
2.
Clean or replace filter/detergent
siphoning tube.
3.
See "Check In-Line Filter" on page 12.
4.
Push nozzle forward for low pressure
mode.
Move throttle
control to FAST position. If
engine still "bogs down", contact Briggs
service facility.
I.
Clean or replace air cleaner.
2.
Fill fuel tank.
3.
Drain gas tanl<; fill with fresh fuel.
4.
Connect wire to spark plug.
5.
Replace spark plug.
6.
Drain gas tank; fill with fresh fuel.
7.
Open choke fully and crank engine.
8.
Contact
Briggs service facility.
9.
Contact
Briggs service facility.
10. Contact
Briggs service facility.
Out of gasoline.
Fill fuel tank.
Dirty air filter.
Choke is opened too soon.
Replace air filter.
Move choke to halfway position until
engine runs smoothly.
U5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1674-0

Table of Contents