GE JP939 Owner's Manual page 7

www, GEApptiances, com
Cooking Guide for Using Heat Settings
High (H) - Q_dck start _br cookim_g;
brim_g water to a boil.
Medium High (7-9) - Fast _D, I :)am_
broil; maim_tah_s a first boll on large
;H_OIIm_ts of fk)od,
Medium (4-6) - Sam_ am]
_)_)_r[_;
mail_taim_s a slow boil o1_ large amoiH_ts
o_ food.
Medium Low (2-3) - Cook a{}er
startim_g at high; cooks with little water
im_covered pa_.
Low (1) - Steam rice, cereal; maimm_im_s
servim_g temperature o{ most {oods.
Slow cookh_g am] simmerim_g.
Lowest (L) -Keeps {hod warm, melts
chocolate am] bl*tter.
At high
or medium-high
settings,
never leave food tmattended.
Boilovers cause smoking; greasy
spillovers may catch
on fire.
It is sati _ to place hot cookware
t]'Oll] the
()veil or surthce tlnits Oil
the glass-ceramic sm'tace when it is
cool. Never place cookware on the
control area.
NOTE: Cooktoptemperatures increasewith the
number of surfaceunits that are on. With 3 or
moreunits turned on, surface temperaturesare
high so be careful when touchingthe cooktop.
Thehot surfaceindicator hght{s)will remain fit
after the surface unit is off until the surface has
cooledbelow 150°E
Fault Code
If an error occurs in the control
operation, a fimlt code will flash
and the control will signal.
To correct:
[]
Touch
the CONTROLLOCKpad to
reset the control.
[_ Attempt to set the control to the
desired
cooking setting.
[_ If the error is not cleared, allow the
cooktop to cool completely:
[] _Mier cooling, touch the CONTROL
LOCKpadagain to
reset the control.
Again attempt to set the control to
the desired cooking setting.
[] If the error is still not cleared, turn
off the cooktop power at the circuit
breaker
or fuse box fi:,r ()lie Illintlte.
[] If the error reappears, call fi:,r
serxice.
®
OR
Dual Surface Unit
The dual stu_i_ce trait has a pan sizing
sensor which will automaticallv set the
small or huge smti_ce m]it to match the
size (ff your pail (see the Using Pan Sizing
section). To ovenide the atltoi/latic l)an
sizing sensor and select the small or huge
surti_ce unit:
[] Touch the dual sm_hce trait
ON/OFF
pad.
[]
Use the (+)/(-)pad
to set the desired
power setting.
[] Touch
the SIZE SELECTpad once to
tm'n on the hu'ge sm'li_ce m]it. Touch
the pad again to mrn on the small
sm_i_ce m]it.
XYhen the indicator light next to the SIZE
SELECTpad is on, the large sm_me unit is
on. X_q_enit is off, the small surlm'e unit
is on.
To mrn the dual sm_i_ce m]it off, touch
the ON/OFF
pad.