Preparing The Motherboard; Installing The Cpu - EVGA Classified SR-2 User Manual

Preparing the Motherboard

The motherboard shipped in the box does
need to purchase these to complete the installation.

Installing the CPU

Be very careful when handling the CPU. Make
sure not to bend or break any pins inside the
socket. Hold the processor only by the edges
and do not touch the bottom of the processor.
Use the following procedure to install the
CPU onto the motherboard.**
**Please ensure that with single processor
usage you are using CPU socket 0 and the adjacent ram bank.
Unhook the socket lever by pushing down and away from the socket.
1.
Put your finger on the tail of the load
2.
plate and press the tail down
Lift the load plate. There is a protective
3.
socket cover in the socket to protect the
socket when there is no CPU installed.
Remove the protective socket cover from
4.
the CPU Socket.
Remove the processor from its protective
cover, making sure you hold it only by the
edges. It is a good idea to save the cover
so that whenever you remove the CPU,
you have a safe place to store it.
EVGA Classified SR-2 Motherboard
not
contain a CPU or memory. You
19