Electrical Connections - GE JGBS04 Owner's Manual & Installation Instructions

In sta llati On ,Instru ctions
i
[] ELECTRICALCONNECTIONS(cont.)
When disconnecting the power cord from the
adapter, always hold the adapter with one
hand. If this is not done, the adapter ground
terminal is very likely to break with repeated
use. Should this happen, DO NOT USE the
appliance until a proper ground has again
been establish ed.
I-B] Usa ge Situations where Appliance Power
Cord will be Disconnected Frequently.
Do not use an adapter plug in these situations
because disconnecting of the power cord
places undue strain on the adapter and leads
to eventual failure of the adapter ground
terminal. The customer should have the
2-prong wall rece ptacle replaced with a
three-prong (grounding} receptacle bg a
qualified electrician before using the
appliance.
The installation of appliances designed for
mobile home installation must conform with
the Hanufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Hobile
Home Construction and Safety, Title 2/4, HUD,
Part 280) or, when such standard is not
applicable, the Standard for Manufactured
Home Installations, latest edition
(lVlanufactured Home Sites, Communities and
Set-Ups}, ANS A225.1, latest edition, or with
local codes, n Canada, mobile home
installation must be in accordance with the
current CAN/CSA Z240/NIH Hobile Home
Installation Code.
Electric Disconnect
• Locate disconnect plug on the range back.
• Pinch sides of connector and pull out of
range back.
[-4"I SEAL THE OPENINGS
_, Seal any openings in the wall behind the-
range and in the floor under the range when
hookups are cam pleted.
[] LIGHT THE PILOTS
.{For models equipped with standing pilots.
If the range is an electric ignition model, the
burners are ignited bg electric ignition which
eliminates the need for standing pilot lights.)
The range should be installed in its permanent
position before any pilots are lit or adjusted,
Jl, CAUTION
- Make sure the surface
burner control knobs are in .the OFF position.
before attain pting to light the pilots.
[] Light the Surf(Ice Burner Pilots
1. Raise the cooktop.
2. Light both pilots with a match.
3. To avoid pilotoutage, use caution when
Closing cooktop after lighting pilots.
NOTE: Do not leave standing pilot it in
a newly constructed or remodeled home or
apartment that will be unoccupied for more
than a month.
Each pilot flame was adjusted at the factory
to be appro×imatelg 5/16" tall. A tinge of yellow
appearing at the upper tip _snormal. If you
find pilot adjustment is necessary, follow
instructions in Step B.
37