GE JD900 Owner's Manual page 29

ge.com
Ovenwill notself-clean
Possible Causes
The oven temperature is
too high to set a self-cleml
operation.
Oven controls improperly set.
What To Do
• _Mlow the oven to cool and reset the controls.
• See the
Using the self-cleaning oven section.
"Crackling"
or This is the sound of the
• This
is normal.
"popping" sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessivesmoking
Excessive soil.
• PYess
the
CLEAR/OFFpad.
O pen
the windows
to
during a clean cycle
rid the room of Slt/oke. Wait until the
LOCKEOlight
goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not Oven too hot. • Allow the oven to cool below locking temperature.
open after a
clean
cycle
Oven not clean after Oven controls not properly set. • See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled. • (3can up heavv, spillovers before ,startiw_,_ the (lean
cycle. Heavily soiled ovens may need to sell:clean
again or for a longer period of time.
"LOCKED"flashes The self-clema cycle has been • (]lose the oven door.
in the display
selected but the door is not
closed.
"LOCKED" Iight is on
The oven door is locked
• Press
the
CLEAR/OFFpad.
_Mh>w the .veil
to cool.
when yon want to cook because the temperature
inside the oven has not
dropped below the
locking temperature.
"T-- and a number You have a traction • Press the CLEAR/OFFpad. Put the oven back into
or
letter"flash
error code. operation.
in thedisplay
If the function code repeats. • Disconnect :ill power to the range for at least
30 seconds and then reconnect power. If the
flmction error code repeats, call for service.
29