GE JD900 Owner's Manual page 13

Usingthe clock, timer and control lockout, gecom
Makesure the clockis set to the
correct time of da,¢
ToSet the Clock
The clock must be set to tile correct time
of dm tot tile autonmfic oxen tinting
flmctions to work properl). Tile time of
da) cannot be changed
during a
timed
baking or self=cleaning cycle,
[] Press tile
CLOCK
pad.
[] Press tile number pads.
[] Press the START pad.
The timer is a minute t#ner onl_
The timer does not control oven
operations. TtTemaximum setting on
the timer is 9 hours and 59mhTutes.
ToSet the Timer
[]
[]
Press tile KITCHENTIMERON/OFF
pad.
Press tile number pads tmtil tile
aiilot/nt of tiI/le _()tl want shows ill
tile display. For example, to set 2
houI_ and 45 nlinutes,
press 2, 4
and 5 in that ordex:
If )ou make a mistake press tile
KITCHENTIMERON/OFF pad and
begin again.
[]
Press tile STARTpad.
After pressing the START pad, SET disappears,
this tells you the time is counting down,although
the display doesnot changeuntil one minute has
passed Seconds will not be shown in the display
until the last minute is counting down.
[] _'_hen tile timer reaches :00, tile
control will beep 3 times followed
by one beep every 6 seconds tmfil
tile KITCHEN TIMER ON/OFF pad
is pressed.
The&second tone can be cance/edby following
the steps in the Special features of your oven
control section under Tones at the Endof a
TimedCycle.
ToReset the Timer
If tile display is still showing tile time
remaining, you may change it by pressing
tile KITCHEN
TIMERON/OFF
pad, then
press tile number pads tmtil tile time w)u
want appea_ in tile display.
If tile remaining time is not in tile display
(dock, delay start or cooking time are in
tile display), recall tile remaining time by
pressing tile KITCHEN TIMER ON/OFF pad
and then pressing tile ntli/lbei" pads to
enter tile new tillle v()[i w}lnt,
ToCancel the Timer
Press tile KITCHEN TIMER ON/OFF pad
twice.
Control Lockout
Your c ontrolwill allowyoutolockout thepress
padsso theycannotbeactivated whenpressed
To h)ck/tmh)ck tile controls:
[] Press the 9 and 0pads at tile same
time tot 3 seconds, tmtil tile display
shows LOC ON.
[] To tmlock tile control, press tile
9 and 0pads at tile same time fi)r
3 seconds, lmfil tile displa) shows
LOC OFF.
When this teatm'e is on and tile press
pads are pressed, tile control will beep
and tile display will show LOCON.
::Ji:: Thecontrollockout m odeaffectsall press
pads.Nopress padswi//workwhenthis
feature is activated
!i> Theadjustment will be retained in memory
after a power failure.
13