Download Print this page

Monogram ZICS360NRFRH Owner's Manual page 14

Bottom-freezer built-in refrigerators

Advertisement

Care and Cleaning
Bottom
Freezer
Refrigerator
Preparing
for vacation
For long vacations or absences, remove food
and shut off power to the refrigerator
at the
fuse box or circuit breaker. Clean the interior
with a baking soda solution of one tablespoon
(15 ml) of baking soda to one quart (1 liter)
of water. Leave the doors open.
For shorter
vacations,
remove
perishable foods
and leave controls at regular settings. However,
if the room temperature
is expected to drop
below 60°F (16°C), follow the same
instructions
as for long vacations.
Set the icemaker
power switch to the O (off)
position
and shut off the water supply to
the refrigerator.
Using
the
Master
Light
switch
This feature
turns offthe
lights in the fresh
food and freezer
compartments.
The switch is located
behind
the grille panel
at the top of the refrigerator.
Lift up the panel
to access the switch.
Light
bulb
replacement
in the
fresh food
compartment
Important: Turning the temperature
control to
OFF does not remove power to the light circuit.
There
are four light bulbs in the top of the
fresh food compartment.
To replace
the bulbs:
1 Set the Master
Light switch in the OFF
position
to turn off the lights. See Using the
Maater Light switch.
2 Remove
the light shield
by placing
your
fingers
in the openings
at the back of the
shield.
Then,
pull the shield
toward you
and swing the back of the shield
down.
3 Replace with the same size bulb (40 watt max.).
4 Reinstall
the shield
and reset the Master
Light switch to the ON position.
Replacement
40-watt bulbs can be purchased
at
your local general
retail store,
through
GE
Parts and Accessories,
800.626.2002,
or at
ge.com.
Order
part # 40A15.
Light
bulb
replacement
in the freezer
compartment
_4
To replace
a bulb:
1 Set the Master
Light
switch in the OFF
position
to turn off the lights. See Using the
Master Light switch.
2 Remove
the freezer
light shield by removing
the two screws with a Phillips
screwdriver.
3 Replace with the same size bulb (40 watt max.).
4 Reinstall
the shield
and reset the Master
Light switch to the ON position.
Replacement
40-watt bulbs can be purchased
at
your local general
retail store,
through
GE
Parts and Accessories,
800.626.2002,
or at
ge.com.
Order
part # 40A15.

Advertisement

loading