GE EER2000 Owner's Manual page 31

ge.com
"F- anda number
or letter"flash
in thedisplay
Possible Causes What To Do
You have a function
error code.
• Discomlect all power to the range for at least 30
seconds and then reconnect power. If the flmcfion
error code repeats, call for service.
• On self-cleaning models, if a flmction error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, flom the locked position. Make sure the latch
is moved to the right as far as it will go. Touch the
Clear/Off pad. Allow the oven to cool for one haul
Put file oven back into operation.
Display flashes "bAd" The installed connection • Contact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone
is miswired.
Display goes blank A fuse in your home may be • Replace file fl_se or reset file circuit breakeL
blown or the circuit
breaker tripped.
The clock is turned off from • See the Using the clock and timer section.
showing in the display,
Display flashes
Power failure.
• Reset the clock.
Unable to get the Oven control pads were • The Bake and Broil Hi/Lo pads must be touched
display to show "SF" not pressed properly, at the same time and held for 3 seconds.
Power outage,
Power outage or surge.
• Reset the clock.
If the oven was in use, you must reset
clock flashes it by touching the Clear/Off pad, setting the clock
and resetting any cooking flmction.
"Burning" or "oily"
This is normal in a new
• To speed
the process, set a self-clean cycle for a
odor emitting from
oven and will disappear mininmm of 3 hours.
See the Using the self-cleaning
the vent
in time. oven section.
Strongodor
An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
31