GE PGP989 Owner's Manual & Installation Instructions page 24

Gas downdraft cooktop
Table of Contents

Advertisement

Available languages

Available languages

Installation
Instructions
UNPACKING THE COOKTOP/INSTALLING THE GASKET
[]
INSTALLING THE FOAM GASKET AND
REFLECTIVE TAPE
-& CAUTION:
Potential risk of fire-
reflective tape must be secured around
countertop
opening as shown.
Do not install the cooktop into the countertop
without
installing the foam gasket as shown.
It protects the bottom edge of the glass from the
countertop
and seals the cooktop against spills.
Remove the cooktop along with its shipping
pad
from the shipping box. Remove the shipping block
from the downdraft
vent opening and place it under
the shipping pad to provide level support.
Centervent shippingblock- place
underthe shippingpadto provide
level support
_4L C AUTION:
GLASS ISFRAGILE.
DO NOT BUMP EDGE OF GLASS DURING
INSTALLATION.
Locate the reflective tape and foam gasket tape
included with gour cooktop.
Smooth rough edges of the cutout.
Install reflective
tape to the opening, along the inside and 3/8" to
1/2" of the opening edge.
Placereflectivetape within 1/2"
)f cutout
Reflectivetapetop
andverticalsides
Peel off the white backing to install the foam gasket
tape on the bottom side of the cooktop glass as shown.
Foam Gasket Installation
Notes:
• The foam gasket tape should be installed within
1/8" of the edge of the glass. Do not stretch or
twist the foam gasket tape.
CAUTION:
Failure to install foam
gasket tape greatlg increases the potential
of breaking the cooktop
glass when installing,
especiallg in Corian ® or granite countertops.
• Use care not to stretch the foam gasket tape
while it is installed or it will not stag in place.
• Do not place foam gasket tape over the metal
flanges.
• Butt the foam gasket tape ends together
at each
corner without
overlapping.
• Trim the foam gasket tape to length without
stretching.
• Mitre cut outside corners of foam gasket tape
slightlg if necessarg for appearance.
:!!\\
FGOa,_e
t
Tape
max. to
GlassEdge
• Do not scratch the glass while cutting the foam
gasket tape.
Note: On PGP989S model, applg the foam tape
around the outer edge of the glass onlg on the sides
and rear of the unit.
24

Advertisement

Chapters

Table of Contents
loading

Table of Contents