GE PGP989 Owner's Manual & Installation Instructions page 23

Installation Instructions
POWER SUPPLYLOCATIONS
GAS SUPPLY:
These cooktops are designed to operate on
natural gas at/4" of water column pressure or
on LP gas at 10" of water column pressure.
• These cooktops ore shipped from the foctorg
set for natural gas. If gou decide to use this
cooktop with LP gas, conversion adjustments
must be made bg o service technician or
other qualified person.
• The pressure regulator must be connected in
series with the manifold of the cooktop and must
remain in series with the supply line regardless
of tgpe of gas being used.
For proper operation, the maximum inlet pressure
to the regulator must be no more than 10" water
column pressure for natural gas and 14" water
column pressure for LP gas.
• When checking the regulator, the inlet pressure
must be at least 1" greater than the regulator
output setting. If the regulator is set for 4" of
water column pressure, the inlet pressure must
be at least 5% If the regulator is set for 10" of
water column pressure, the inlet pressure must
be at least 11% For ease of installation, and if local
codes permit, the gas supply line into the cooktop
should be 1/2" or 3/4" ID flexible metal appliance
connector, three to five feet long.
NOTE: Purchase a new flexible line. DO NOT USE
AN OLD PREVIOUSLY USED LINE.
• Make gas connection through rear wall, or on
cabinet floor at rear, as illustrated.
ELECTRICAL SUPPLY:
I
I
29_½ " rain3, - - , Electrical o utlet 12" above
min cabinet f loor
__ (mounton side
or backcabinet
wall 2" min.
from centerline)
4" (to clear toe kick area)
The built-in gas downdraft cooktop features
pilotless electric ignition for energy savings and
reliability. It operates on a 120-volt, 60-Hz power
supply. A separate circuit, protected bg a 15-amp
time-delag fuse or circuit breaker, is required.
• A properlg grounded 3-prong receptacle should
be located within reach of cooktop's four foot
power cord.
IMPORTANT: (Pleese reed cerefullg.) FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
The power cord of this appliance is
equipped with a three-prong (grounding) plug
which mates with a standard three-prong
grounding wall receptacle to minimize the
possibilitg of electric shock hazard from this
appliance. The customer should have the wall
receptacle and circuit checked bg a qualified
electrician to make sure the receptacle is properlg
grounded and has correct polaritg.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibilitg and
obligation of the customer to have it replaced with
a properlg grounded three-prong wall receptacle.
Do Not, Under Any Circumstences, Cut Or
Remove The Third (ground) Prong From The
Power Cord.
Do not use an extension cord.
23