Advertisement
Installation
Instructions
[_
CONNECT AND RUN THE VALVE
DRAIN HOSE ICONT.i
• Elevating the drain hose mag cause back
pressure that could reduce the brine draw during
recharge. If raising the drain line overhead
is
required to get to the drain point, measure the
inlet water pressure to the softener first. For inlet
pressures between 20 and 50 psi, do not raise
higher than 8' above the floor. For inlet pressure
above 50 psi, the drain line mag be raised to a
maximum
height of 14'.
Fig. 4A
Valve
drain
hose
! P /' ". g_I_
STANDPIPE
11½"air gap
FLOOR DRAIN
CONNECTING
A RIGID VALVE DRAIN TUBE
To adapt a copper drain tube to the softener, bug a
compression
fitting (1/4 NPT x 1/2" O.D. tube) and
needed tubing from gour local hardware
store.
1/4" NPT
thread
Compression
fitting
1/4 NPT x 1/2" O.D.
tube
(not provided)
/
I
Cut barbs
from
valve
drain
elbow
(pull clip
and remove
drain
valve
elbow
from
valve)
1/2" outside
diameter
copper
tube
(not provided)
[6]
INSTALL TIMER AND COVERS AND
MAKE HARNESS CONNECTION
_f]
BRINE TUBING CONNECTION
• Route the brine tubing out of the largest hole in
the brine tank sidewall. Use the compression
nut
(in parts bag) to connect tubing to the nozzle
assemblg
at the main valve.
Compression
nut
Nozzle
assembly
Brine tubing
assembly
Brine tank
J
I8]
INSTALL THE BRINE TANK
OVERFLOW FITTINGS AND HOSE
• Insert the rubber grommet
into the 3/4" diameter
hole in the brine tank sidewall as shown.
Push the end of the hose adapter
elbow into the
grommet
as shown.
Attach a length of hose (use remaining
hose from
Step 5) to the hose adapter elbow. Use a hose
clamp to hold it in place.
Locate the other end of the hose at the drain
point. DO NOT ELEVATE this hose higher than the
elbow on the brine tank.
IMPORTANT: DO NOT TEE OVERFLOW HOSE
TO VALVE DRAIN HOSE.
NOTE: This drain is for safetg onlg. If the cabinet
(brine tank) should
over-fill with water,
Grommet
the excess is carried
to the drain.
Hose
adapter'_
Venturi
nozzle
Overflow
drain hose
Brine
tank
I
-.
.....
-÷
To sewer drain
See separate instructions
included in box with parts.
8
Advertisement
