Advertisement
About the water softener
system.
°d'-; -
LaSr_GE
WArS_ MAt_GE_T
SY_T_
Switch
Turbine
count
Valve
Minutes of cycle
position
rernaining
Id "i,C
id
rlt_
wArERMAt_G_ENTSrSr_
........ i-I r"li'l
""- Ij
IjIj
Service: Manually
Initiated Electronic Diagnostics
F_]To enter diagnostics, press and hold the DATA button until the display appears as shown.
NOTE: Ifthe softener is in the middle of a regeneration, top part of the display shows the cycle
of regeneration and minutes of the cycle remaining. If two cycle names are flashing, the valve
is in transition between the cycles.
A The three digits under WATERMANAGEMENT SYSTEM indicate water meter operation
as follows:
!i_: 0 00 (steady)= soft water not in use_.noflow through the meteE
--OPEN A NEARBYSOFTWATERFAUCET--
!;_ 000 to 140 (continual)= repeats display for each gallon of water passing through the
meteE
_,
_
Motor
!
_
Sensor
I_
housing
I _
_
Turbine
-_1_
------_Turbine
Valve _
support &
outlet _
shaft
If you don't get a reading in the display, with faucet open, pull the sensor from the valve outlet
port. Passa small magnet back and forth in front of the sensoEYou should get a reading in the
display. If you get a reading, shut off water supply, unhook the in and out plumbing and check
the turbine for binding.
B This display segment (_x.i),
in the following chart, indicates an open POSITION switch.
Use the TOUCHor HOLD button to manually advance the valve into each cycle and check
correct switch operation.
CORRECT SWITCH
DISPLAYS
VALVE CYCLE STATUS
Valve in service, fill, brining, backwash
or fast rinse position,
Valve rotating from one position to anotheE
I
I
WAT£eMAN4_NTS_rEM
--I
Clb,o
[_ Pressthe DATAbutton again, This diagnostic display shows the total number of recharges (top)
since the timer was connected to electrical powe_
The number of days since the timer was connected to electrical power is shown in the bottom
part of the display. If over 1999 days, a (×10)indicator shows, meaning you must multiply the
number shown by 10.
[_ PressDATAonce again to return the present time to the display.
18
Advertisement
