GE JBP19 Owner's Manual page 32

_iii!iiiiilJiiii_iilli!iiiiiiiji
Installation of the range.
Read these instructions completely and carefully.
[] 3-Wire Power Cord Installation
A WARNING:
The neutralor ground wire of the power cord
must be connected to the neutral terminal located in the center of the
connector block. The power leads must be connected to the outside
(brass colored) terminals.
Remove tile 3 wire terminal screws [['Oli1 tile connector block. Insert screws
through each power cord terminal ring and into tile connector block until the
screws
engage
tile ll[ltS, l_e cei't_lin that the center wire is connected to tile center
screw ot the connector block. Tighten screws securely.
Do NOT remove ground strap connection.
Neutral terrninal
Power c ord
Connector block
_ Ground strap
ii!iii_iiiiiiiiiii!iiii!i!_i_iiii
iiiii!i!i iiiiHi