How To Mount The Connector Tube - Craftsman 502.255070 Owner's Manual

HOW TO MOUNT THE CONNECTOR TUBE
ASSEMBLY
Mount the connector tube with the fasteners shown full size below.
(A) (C)
26x239 4X24
@
(B)
t 5X89
Q
(E)
t5x66
(D)
4x71
1, Assemble the handle and the rubber latch to the connector
tube with the fasteners (Figure 20), Hold screws (A) with a
screwdriver and tighten Eocknuts (B),
2. Align the two holes in the connector tube with the tab on the
elbow° Slide the connector tube into the elbow until the se-
cond line on the decal is even with the edge of the elbow
3o Fasten the elbowto the connector tube with screw (A), Push
screw (A) through the tab on the elbow° Tighten screw (A) until
the head of the screw touches the elbow.
4, Move the lift lever to the lowest position,
5. Hold the handle on the connector tube (Figure 21),, Put the
edge of the elbow in the hole of the cover, Move the connector
tube and elbow to the left until the elbow locks in place,
6,, Align the rubber latch with the latch pin (Figure 22),
7 Slide the connector tube over the extension tube,,
8, Lock the rubber latch to the latch pin,,
A
/
Align the tab with the hole
Elbow
Connector]
?
M,II I I
C
Rubber
Latch
D Figure 20
Handle
Cover Elbow
Connector Tube
Figure 21
Connector
Tube
Lock Rubber Latch
To Latch Pin
E_ensionTube
Figure 22
F-936o2 t7