How To Install The Battery - Craftsman 502.255070 Owner's Manual

ASSEMBLY
HOW TO INSTALL THE BATTERY
Use the fasteners shown below to install the battery, The fasteners
are shown at full size.
(A)
91565
(B)
32618
Q
(c)
15x66 lx38
Attach the drain tube to the bottom of the battery tray
(Figure 6)° Fasten the drain tube with clamp (A), Push the
drain tube through the hole in the frame,,
2,_
Pull the drain tube along the frame to the rear of the unit
(Figure7),.Make sure the drain tube isabove the clutch idler
spring. Fastenthe drain tube to the side ofthe frame withtie
strap(B).
3_
Set the battery in the battery tray. Make sure the battery
terminals are toward the center of the frame (Figure 6).. Make
sure there are not any wires under the battery or the battery
tray.
4_ Fasten the battery with the battery clamp. Make sure there
are not any wires between the battery and the battery clamp.
5_
If equipped, slide the terminal cover onto the red cable
(Figure8), Fasten the red cable to the positive (+) terminal
withthe fasteners as shown. Pushthe terminal cover ontothe
battery terminal
_ WARNING: To prevent sparks, fasten the red cable to
the positive (+) terminal before you connect the black
cable°
6_ Fasten the black cable to the negative (-) terminal with the fas-
tenets as shown.
7. To prevent corrosion, apply grease to the battery terminals.
Battery Clamp
i
Battery Tray
C
Figure 6
Drain Tube 1
Clutch Ic[lerSp_ng O
B
Figure 7
Positive
Terminal Cover
Batter
Black Cab
D
F-93602 10