Air Quality Sensor; Filter Replacement; Filter Maintenance; Filter Replacement Lights - Philips AC4072 User Manual

English
16

Air quality sensor

Clean the air quality sensor every 2 months for optimal functioning of
the appliance. Clean it more frequently if you use the appliance in a dusty
environment.
Note: When the humidity level in the room is very high, it is possible that
condensation develops on the air quality sensor. As a result, the AIR QUALITY
light on the control panel and the air quality light ring may indicate that the air
quality is bad even though the air quality is good. In this case you have to clean
the air quality sensor or use one of the manual speed settings.
1 Clean the air quality sensor inlet and the air quality sensor
outlet with a soft brush.
2 Remove the air quality sensor cover.
3 Clean the air quality sensor, the dust inlet and the dust outlet with a
lightly moistened cotton swab.
4 Dry them with a dry cotton swab.
5 Reattach the air quality sensor cover.

Filter replacement

Filter maintenance

This appliance is equipped with the Healthy air protect lock to ensure that
the filters are in optimal condition when the appliance is operating.
When one of the filters is almost full and has to be cleaned or replaced,
the appropriate filter replacement light starts to flash. When you do not
replace filter 2, filter 3 and/or filter 4, the appliance stops operating and the
appliance is locked.
When the appliance is locked, the filter replacement light of the filter
concerned lights up on continuously.
Note: Only replace a filter when the corresponding filter replacement
light flashes. If you replace the filter before the filter replacement light starts
flashing, the lifetime counter will not be reset but will continue counting the
lifetime of the previous filter. As a result, the filter replacement light will start
flashing much too soon.

Filter replacement lights

The filter replacement lights indicate which filter has to be cleaned or
replaced.