Table of Contents
Advertisement
Available languages
Available languages
DEPTH ADJUSTMENT
Disconnect
plug from power
source.
Loosen
the depth
adjustment
lever
located
in the
housing
of saw. Hold the foot down with one
hand and raise or lower saw by the handle.
I=1[_I [_!
DEPTH
BRACKET
Tighten
lever
at the depth
setting
desired.
Check desired depth (Fig. 3).
Not more than one tooth length
of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
m
DEPTH
LEVER
BLADE WRENCH
& STORAGE AREA
ONETOOTH LENGTH SHOULD
PENETRATE
WOOD FOR
MINIMUM SPLINTERING
90 ° CUTTING
ANGLE CHECK
Disconnect
plug from power source. Set foot to
maximum
depth of cut setting.
Loosen
bevel
adjustment
lever,
set to 0 ° on quadrant,
retighten
lever
and
check
for
90 ° angle
between
the blade and bottom
plane of foot
with a square
(Fig. 5). Make adjustments
by
turning the small alignment
screw, if necessary.
BEVEL
J_
ADJUSTMENT
90° ....__ __
LEVER
---ALIGNMENT
SCREW
LFOOT
BLADE
BEVEL ADJUSTMENT
Disconnect
plug from power source. The foot
can be adjusted
up to 56 ° by loosening
the
bevel adjustment
lever at the front of the saw.
Align to desired
angle on calibrated
quadrant.
Then tighten bevel adjustment
lever (Fig. 6).
Because
of the increased
amount
of blade
engagement
in the work
and decreased
stability
of the foot, blade binding
may occur.
Keep the saw steady and the foot firmly on the
workpiece.
BEVEL
ADJUSTMENT
LEVER
QUADRANT
-9-
Advertisement
Table of Contents
