Aiwa NSX-MA845 Operating Instructions Manual page 15

RADIO RECEPTION
_ o II-O
DO0o
DOOQ
DOOQ
DO
3
_Q_O
-MONa
TUNER
1 Press TUNER/BAND repeatedly to select the
desired band.
I-_FM-_AM_
When TUNER/BAND is pressed while the power is off, the
power is turned on directly.
2 Press _ DOWN or _ UP to select a station.
Each time the button is pressed, the frequency changes,
When a station is received, "TUNE" is displayed for 2 seconds.
During FM stereo reception, ((€(_))) is displayed.
(l((_))f)
TUNE
f-
To search for a station quickly (Auto Search)
Keep HI< DOWN or _ UP pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press _ DOWN or I_H
UP.
• The Auto Search may notstop at stationswith very weak signals.
_o]W-
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control so that "MONO"
appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that "MONO"
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use thisunit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing <11_.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
1
2
)oo
)oo
)oo
o o TUNER
o 0 BAND
30
_ -0-9,+10
The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station. Use the preset
number to tune in to a preset station directly.
1 PressTUNER/BAND to select a band, and press
DOWN or _ UP to select a station.
2 Press II SET to store the station.
A preset number beginning from 1 in consecutive order for
each band is assigned to the station.
Preset number
3 Repeat steps 1 and 2.
The next stationwill not be storedif a total of 32 preset stations
for all the bands have already been stored.
"FULL' is displayed if you attempt to store more than 32 preset
stations.
PRESET NUMBERTUNING
Use the remote control to select the preset number directly.
1 Press TUNER/BAND to select a band.
2 Press numbered buttons 0-9 and +10 to select a
preset number.
Example:
To select preset number 20, press +10, +10 and a.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Then, press 411_
repeatedly or turn MULTI JOG.
Each time <11_ is pressed, the next ascending number is
selected.
To clear a preset station
Select the preset number ofthe stationto be cleared.Then, press
• CLEAR, and press II SET within 4 seconds.
The oreset numbers of all other stations in the band with hiQher
Q
Z
0
(/)
o
<