Table of Contents
Advertisement
4.
Turn the [TYPE] knob to select
the "MIDI Tx Ch" (MIDI transmit
channel) parameter.
[TYPE] knob
5.
Turn parameter knob 1 to select
the MIDI channel (1 – 16) on
which the B9.1ut will send MIDI
messages.
6.
When the setting is complete,
press the [EXIT] key to cancel the
SYSTEM menu.
I f a set t i ng was cha nge d, t he i nd icat ion
"Store...?" appears on the display, to allow you
to store the changes.
If no setting was changed, the unit returns to the
previous mode.
7.
Press the [STORE/SWAP] key to
save the changes.
The MIDI channel setting is accepted, and the
unit returns to manual mode or play mode.
By pressing the [EXIT] key, you can abort the
changes and return to the previous mode without
saving.
ZOOM B9.1ut
Sending and receiving
patch switching information
via MIDI (program change)
You can send and receive patch changing
information of the B9.1ut via MIDI as program
cha nge or ba n k select + progra m cha nge
messages.
There are two ways (program change modes) for
doing this, as described below.
● Direct mode
With this method, you use a combination
of MIDI bank select and program change
messages to specify the patch.
HINT
• Bank select is a MIDI message type for
specifying the sound category of a synthesizer
or similar. It is used in combination with
program change messages.
• Normally, bank select is specifi ed in two parts,
using the MSB (most signifi cant byte) and LSB
(least signifi cant byte) value.
● Mapping mode
With this method, you use only the MIDI
program change messages to specify the
patch. A program change map is used to
assign program change numbers 0 – 127 to
patches, and patches are then selected using
the mapping information. With this method, a
maximum of 128 patches can be specifi ed.
■ Enable program change send/receive
The procedure for enabling send/receive of
program change (+ bank select) messages is
described below.
1.
In manual mode or play mode,
press the [SYSTEM] key.
MIDI Usage Examples
43
Advertisement
Table of Contents
