Editing A Patch - Zoom 606 Guitar Operation Manual

Editing a Patch

Editing means changing the various effect parameter settings of a
patch. Use an existing patch as a starting point and adjust the
parameters to create your own and original sound.
Select the effect parameter
Use the PLAY/EDIT selector to select the module
and parameter you want to edit.
The 606 switches to the edit mode and the value of the currently
selected effect parameter appears on the display. When the 606
is in edit mode, a dot is
shown in the bottom right
corner of the display.
Parameter value
3 0 3 3 0
Lit
For information on effect
modules and parameters,
see the section "Effect
Parameters" at the end of
this manual.
The DRIVE module
can also be directly
edited by using the
DRIVE selector and
GAIN [+] / [-] keys
( p. 14).
Terminate the edit mode
Set the PLAY/EDIT selector to "PLAY". The
unit reverts to the play mode.
16 ZOOM 606
GUITAR
Adjust the parameter setting
value
Use the VALUE [+] / [-] keys.
The keys operate as follows.
• Keeping one key depressed: Value changes continuously.
• Hold down one key while pressing the other key: Value
increases rapidly.
• Pressing both keys simultaneously: Switch to next effect
type in same module.
NOTE
The editing changes made in this way are only temporary. When
NOTE
you return to the play mode and select a different patch, the
settings will revert to the original condition. If you want to keep the
change, store the settings before switching the patch (
Editing a Patch
Changing the
module on/off
setting
Press both [W] / [Q] foot
switches together.
This switches the effect module
selected with the PLAY/EDIT
selector on or off.
When the PLAY/EDIT selector
is set to "CONTOUR" or
"TIME", pressing the [W] / [Q]
foot switches together has no
effect.
p.18 ).
ZOOM 606
GUITAR
17