Listening To Patches (Play Mode Operation); Panel Display In Play Mode; Selecting A Patch - Zoom 708II Bass Operation Manual

Listening to Patches
The condition where you call up patches stored in the memory of the 708II and use them for
playing your instrument is called "play mode". This is the condition the unit is in when you
turn the power on. The various operations possible in play mode are described in this
section.

Panel Display in Play Mode

In play mode, the panel shows the following information.
Patch name
Module LEDs corresponding to modules that
are ON in the currently selected patch are lit.

Selecting a Patch

1.
In play mode, press one of the
W Q
[ ]/[ ] foot switches.
Q
Pressing the [ ] foot switch moves to the next
higher patch, and pressing the [
moves to the next lower patch.
USER group
A 0 A 1
PRESET group
0 0 0 1
2.
To directly switch the bank, use the
W
TYPE [ ]/[
Pressing the TYPE [
higher bank, and pressing the TYPE [
moves to the next lower bank.
10
ZOOM 708II BASS
Bank (A - F, 0 - 5)
W
] foot switch
A 9 B 0 F 9
5 9
0 9 1 0
Q
] keys.
Q
] key moves to the next
W
(Play Mode Operation)
Patch number (0 - 9)
A 0
When a dot (.) is shown here, an
effect parameter has been changed.
When a dot (.) is shown here, patches
can be selected from either the USER
group or the PRESET group.
N
OTE
While playing a rhythm pattern, direct bank
selection is not available.
3.
It is also possible to set up the unit so
that only patches from the USER
group or from the PRESET group are
switched. To do this, press both TYPE
W Q
[ ]/[
With each push, the group from which patches
can be selected is toggled as follows.
Both groups
0 2
H
INT
] key
To set up the unit so that the patch sound is
switched only after confirmation, see p. 23.
] keys together.
PRESET group
USER group
only
only
A 2 0 2