Using The Tuner Function - Zoom 606 Guitar Operation Manual

Using the Tuner Function

The 606 incorporates an auto-chromatic tuner for guitars. To use the
tuner function, the built-in effects must be bypassed (temporarily
turned off) or muted (original sound and effect sound turned off).
The tuner function is not available if the PLAY/EDIT selector is set to
NOTE
a position other than PLAY.
Switch to bypass or mute
Press both [W] / [Q]
foot switches
together.
Pressing and
immediately releasing
the switches sets the unit
to the bypass condition.
Pressing and holding the
switches for at least 1
second sets the unit to
the mute condition.
Bypass Mute
Tune the
guitar
Play the open string
you want to tune,
and watch the
display.
The left side of the display shows
the note which is closest to the
current pitch.
12 ZOOM 606
GUITAR
Adjusting the reference pitch of
the tuner
The default reference pitch of the tuner (the setting which is
established when the unit is turned on) is center A = 440 Hz.
You can fine-adjust this reference pitch if desired.
Press one of the VALUE [+] / [-] keys.
Pitch is high Pitch is correct Pitch is low
Indication turns faster the more the pitch is off.
Using the Tuner Function
The current reference
pitch is shown for about
2 seconds. The default
setting is "40" (center A
= 440 Hz).
Use the VALUE [+] / [-] keys
to adjust the setting.
The setting range is 35 - 45 (center
A = 435 to 445 Hz).
When power to the unit is
turned off and on again, the
setting reverts to the default
of "40" (center A = 440 Hz).
Return to play
mode
Press one of the [W] / [Q]
foot switches.
The right side of the
display shows a symbol
that indicates by how
much the tuning is off.
Tune the other
strings in the same
way.
ZOOM 606
GUITAR
13